Hanna-instruments HI 254 Manual de usuario descargar pdf (Pagina 19)

BEEP STATUS SET

Press CAL when the beep status is displayed. Beep status (On or OFF) will

start blinking.

Press the ARROW keys to change the beep status (On or OFF).

Press CFM to save the modified beep status.

Press CAL to escape without saving.

BAUD RATE SET

Press CAL when the baud rate is displayed. The baud rate (600, 1200, 2400,

4800 or 9600) will start blinking.

Press the ARROW keys to change the baud rate value.

Press CFM to save the modified baud rate value.

Press CAL to escape without saving.

SERIAL COMMUNICATION COMMAND PREFIX SET

Press CAL when the command prefix is displayed. The command prefix (0 to

47) will start blinking.

Press the ARROW keys to change the command prefix.

Press CFM to save the modified command prefix value.

Press CAL to escape without saving.

Note:  See the PC interface section on page 25 for a complete explanation.

 The command prefix must be 16 if HI 92000 PC software is used.

CALIBRATION ALARM TIME-OUT SET

Press CAL when the calibration time-out is displayed. Calibration time-out

(OFF or 1 to 7 days) will start blinking.

CAL

INTV

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Sin comentarios

Hanna-instruments HI 254 Manual de usuario Pagina 19