Hanna-instruments HI 904 Manual de usuario descargar pdf (Pagina 56)

4-10

GENERAL OPTIONS

Disconnect the KF electrode, then connect the HI 900940 calibration key to the electrode

input (BNC connector).

Depending on which parameters you want to check, follow the indications below:

Checking the mV input accuracy:

Set the multimeter to mV mode.

If necessary, switch the calibration key to mV mode by pressing the red button.

Connect the calibration key banana plugs to the multimeter mV input.

Choose the current value using the and keys (from the pre-defined list).

Check if the millivolts indication is in accordance with the value displayed on the titrator

screen (within 2% accuracy).

Checking the µA output accuracy:

Set the multimeter to µA mode.

If necessary, switch the calibration key to µA mode by pressing the red button.

Connect the calibration key banana plugs to the multimeter mA input.

Check for the multimeter indication to be in accordance with the titrator µA prescribed value.

4.11 Set Up Balance Interface

This screen allows the user to setup an analytical balance for automatic acquisition of sample

mass prior to titration.

The balance is connected to the titrator via RS 232 interface.

Press to add a new balance to the list.

Press to enable the balance interface feature.

Press to disable the balance feature (automatic mass acquisition will not be available).

Press to customize the serial communication parameters. The

Balance Configuration

screen will open.

Press to remove the highlighted balance. Note: At least one balance must be on the

list.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 179 180

Sin comentarios

Hanna-instruments HI 904 Manual de usuario Pagina 56