Hanna-instruments HI 98160 Manual de usuario descargar pdf (Pagina 28)

PC INTERFACEPC INTERFACE

PC INTERFACE

Data transmission from the instrument to the PC can be done with the

HI 92000 Windows

compatible software (optional). HI 92000 also

offers graphing and an on-line help feature.

Data can be exported to the most popular spreadsheet programs for

further analysis.

To connect your instrument to a PC, use a standard USB cable. Make

sure that your instrument is switched off and plug one connector to the

instrument’s USB socket and the other to the USB port of your PC.

Note: If you are not using Hanna Instruments HI 92000 software,

please see the following instructions.

In order to avoid data errors the serial communication interface is not

available if the battery percentage is less than 30%. The instrument will

answer with “Err9” message.

SENDING COMMANDS FROM PC

It is also possible to remotely control the instrument with any terminal

program. Use a standard USB cable to connect the instrument to a PC,

start the terminal program and set the communication options as follows:

8, N, 1, no flow control, baud rate 9600.

COMMAND TYPES

To send a command to the instrument follow the next scheme:

<command prefix> <command

<CR>

where: <command prefix> is 16 ASCII character.

<command> is the command code.

Note: Either small or capital letters can be used.

SIMPLE COMMANDS

RNG Is equivalent to pressing RANGE

MOD Is equivalent to pressing MODE

CAL Is equivalent to pressing CAL

CFM Is equivalent to pressing CFM

UPC Is equivalent to pressing the UP arrow key

DWC Is equivalent to pressing the DOWN arrow key

LOG Is equivalent to pressing LOG

RCL Is equivalent to pressing RCL

SET Is equivalent to pressing SETUP

CLR Is equivalent to pressing CLR

OFF Is equivalent to pressing OFF

AED Is equivalent to pressing AutoEnd

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Sin comentarios

Hanna-instruments HI 98160 Manual de usuario Pagina 28