73
“
High ORPHigh ORP
High ORPHigh ORP
High ORP” on LCD and “
H ORPH ORP
H ORPH ORP
H ORP” on SMS
The ORP is over the Alarm High setpoint.
Change the setpoint, verify the ORP probe.
“
Low ORPLow ORP
Low ORPLow ORP
Low ORP” on LCD and “
L ORPL ORP
L ORPL ORP
L ORP” on SMS
The ORP is under the Alarm Low setpoint.
Change the setpoint, verify the ORP probe.
“
High THigh T
High THigh T
High T
emperatureemperature
emperatureemperature
emperature” on LCD and “
H TH T
H TH T
H T
empemp
empemp
emp” on SMS
The Temperature is over the Alarm High setpoint.
Change the setpoint, verify the pH probe.
“
LL
LL
L
ow Tow T
ow Tow T
ow T
emperatureemperature
emperatureemperature
emperature” on LCD and “
L TL T
L TL T
L T
empemp
empemp
emp” on SMS
The Temperature is under the Alarm Low setpoint.
Change the setpoint, verify the pH probe.
WARNING MESSAGES
“
Dirty CellDirty Cell
Dirty CellDirty Cell
Dirty Cell” on LCD and “
Drt CellDrt Cell
Drt CellDrt Cell
Drt Cell” on SMS
The light level is too low. The light source current is near the
highest value. The cell is dirty or the water is too turbid.
Check the water quality; check the water flow; Clean the cell.
“
Reagent Low LevelReagent Low Level
Reagent Low LevelReagent Low Level
Reagent Low Level” on LCD and “
L ReagL Reag
L ReagL Reag
L Reag” on SMS
The reagent reach the 20% of the initial quantity. The re-
agent level is based on a “blind” counting of the com-
pleted measurements. A difference between reagent counter
and real reagent level could appear.
Change the reagent or reset the reagent counter.
“
Cl Calibration Old
Cl Calibration Old
Cl Calibration OldCl Calibration Old
Cl Calibration Old” on LCD and “
Cl CalCl Cal
Cl CalCl Cal
Cl Cal” on SMS
Cell calibration is older than 1 months.
Calibrate the cell.
“
RR
RR
R
eagent Expiredeagent Expired
eagent Expiredeagent Expired
eagent Expired” on LCD and “
RR
RR
R
eag Expeag Exp
eag Expeag Exp
eag Exp” on SMS
Reagent is older than 3 month. The reagent expiration
time is started when reagent counter is reset or “prime
reagent pump command is executed.
Change the reagent and reset the reagent counter.
“
GSM Wrong PIN CodeGSM Wrong PIN Code
GSM Wrong PIN CodeGSM Wrong PIN Code
GSM Wrong PIN Code”: appears on LCD
Wrong PIN code was entered.
Set the correct pin code and restart the analyzer.
“
GSM Init failedGSM Init failed
GSM Init failedGSM Init failed
GSM Init failed”: appears on LCD
The GSM modem was not successfully initialized.
Wait for auto retry. Verify other messages related to GSM.
“
GSM Card ExpiredGSM Card Expired
GSM Card ExpiredGSM Card Expired
GSM Card Expired”: appears on LCD
The SIM expiration date is reached.
Comentarios a estos manuales