Hanna-instruments HI 9017 Manual de usuario descargar pdf (Pagina 5)

FRONT PANEL ANDFRONT PANEL AND

FRONT PANEL AND

SPECIFICATIONS OF HSPECIFICATIONS OF H

SPECIFICATIONS OF H

90179017

9017

1. Program descriptions

Briefly describes the 6 programs

2. Temperature LCD

This LCD displays the temperature measured by the HI7669/2W

probe or the value that was manually set through the keyboard.

If the temperature has been set manually, the "°C" symbol will

flash.

When the temperature probe is connected the measured tempera-

ture is displayed and the "°C" symbol stops flashing.

When the temperature measured by the probe is out of range (-10

to 125°C) the "Err3" signal appears.

3. pH and mV LCD

This LCD displays the pH or mV reading (pH and mV is toggled

with the RANGE key). The corresponding pH or mV symbol will be

displayed along with the measured value.

An error signal ("Err1", "Err2", "Err4" or "Err5") will appear on this

display to indicate that the range is exceeded or that the buffer

used for calibration is not recognized by the meter's microproces-

sor.

4. Keyboard

ENTER A key used in programming.

ENTER B key used in programming.

CLEAR key to clear entry or silence alarm.

PGM key to select a program.

OFF

ins rum n

CON

RANGE

+/-

CAL

TEMP

ENTER

CLEAR

PGM

HI 9017 MICROPROCESSOR pH METER

PROGRAMS

to enter temperature alarm

to enter pH end point alarm

to enter RS 232 ESC code

to exit from any program

to clear entry or silence alarm

to manually enter calibration buffer value

to enter pH alarm

to enter mV alarm

PGM

ENTER ENTER

ENTER

1st buffer 2nd buffer

upper limit lower limit

end point value alert value

ESC code

CLEAR

Standard pH buffer - 4.01, 7.01, 10.01

pH°C

1 2 3 4 5 6 7 8 9 10 ... 63 64

Comentarios a estos manuales

Sin comentarios

Hanna-instruments HI 9017 Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Hanna-instruments HI 9017